Configure properties on vendor list (U.S. Multi-State Privacy)

   Permission: Regulation Settings - USNat

Properties associated with a U.S. Multi-State vendor list will inherit the vendors, privacy choices, translations, etc... configured for the vendor list. This information will be surfaced in privacy managers, OTT messages, and/or first layer messages configured for the property.

In this article, we will cover how to perform the following for a pre-existing U.S. Multi-State Privacy vendor list: 

To start, navigate to a U.S. Multi-State Privacy vendor list by selecting Vendor Management from the left-hand rail and clicking U.S. Multi-State Privacy from the menu. 

Screenshot 2023-11-27 at 8.30.14 AM.png

Select a U.S. Multi-State Privacy vendor list on the subsequent page.

Screenshot 2023-11-27 at 11.35.28 AM.png

Navigate to the Property Selection section of the Name and Property tab.

Screenshot 2023-11-27 at 11.39.23 AM.png


Add property to vendor list

Ensure the Properties tab is selected. Add a property to the vendor list by selecting the toggle to the right of the property name. Selected properties will appear in the right-hand pane of the section.

If the selected property belongs to a property group, the property will be listed under the property group name. Otherwise, the property will be listed under Not in any property group.

Screenshot 2023-11-27 at 1.09.41 PM.png

Click Save to confirm your additions.


Remove property from vendor list

To remove a property from the vendor list, navigate to the right-hand pane of the Property Selection section and click the X to the right of the property name. 

Screenshot 2023-11-27 at 1.16.17 PM.png

The property will be removed from the vendor list. Click Save to confirm the removal(s).


Add property group to vendor list

Ensure the Groups tab is selected. Add a property group to the vendor list by selecting the + to the right of the property group name. Selected property groups will appear in the right-hand pane of the section and list all the properties contained within that group.

  Note: If an individual property was added and it also belongs to a property group you will be unable to add the property group to the vendor list. In this case, you will first need to remove the individual property first and then add the property group.

Screenshot 2023-11-27 at 2.42.23 PM.png

Click Save to confirm your additions.


Remove property group from vendor list

To remove a property group from the vendor list, ensure the Groups tab is selected and click the - to the right of a property group name. 

Screenshot 2023-11-27 at 2.53.11 PM.png

The property group will be removed from the vendor list. Click Save to confirm the removal(s).

 

 

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.